FAQ - WingLine L
In this section frequently asked questions are answered and some product features are indicated.
Search
Results:
-
WingLine L
Closing one door set opens the adjacent one.
The door is pushed open by displaced air. Separate the cabinet segments with a central wall flush with the corpus or provide ventilation (e. g. in the rear wall).
-
WingLine L
The door can not be closed all the way.
1. Solution approach
The running component is knocking against the carcase side as the cup distance for the cup drilling is too small.
- The cup distance for the cup drilling is 5.0 mm.
2. Solution approach
The running and guide profiles are not mounted parallel to the upper and lower floor.
- The profiles must be mounted in parallel with the mounting aid.
3. Solution approach
Due to strong deflection of the door, the door edge strikes against the side of the carcase.
- Door deflectors or door clamps are recommended.
-
WingLine L
The door does not close by itself on the last few millimetres.
Hinges with self closing feature must be used.
-
WingLine L
The door does not open all the way.
1. Solution approach
- The cabinet is not in the scale and must be aligned.
- The doors must be aligned.
- The doors are aligned, but the hinges are under tension. Make sure that the joint front to body is even.
2. Solution approach
The running and guide profiles are not mounted parallel to the upper and lower floor.
- The profiles must be mounted in parallel with the mounting aid.
3. Solution approach
The door has been lowered too far by height adjuster, making guide component scrape on profile.
4. Solution approach
The central hinge has been mounted incorrectly or the pivot point offset is not correct.
- Mount the central hinge according to the assembly instructions.
5. Solution approach
Door damper not shortened for full overlay.
- Shorten the door damper
-
WingLine L
The door only opens by a few millimetres.
The running component is knocking against the carcase side as the cup distance for the cup drilling is too small. The cup distance for the cup drilling is 5.0 mm.
-
WingLine L
The door opens too slowly.
1. Solution approach
- The cabinet is not in the scale and must be aligned.
- The doors must be aligned.
- The doors are aligned, but the hinges are under tension. Make sure that the joint front to body is even.
2. Solution approach
The running and guide profiles are not mounted parallel to the upper and lower floor.
- The profiles must be mounted in parallel with the mounting aid.
3. Solution approach
- The door has been lowered too far by the height adjuster, making guide component scrape on profile.
- Raise the door with the aid of the height adjustment until the guide part does not grind.
- The door has been pulled up to high by the height adjuster.
- The door must be lowered via the height adjustment so that it runs smoothly.
4. Solution approach
- The guide part is not locked to the profile.
-
WingLine L
The door sags in closed position.
The profile sags, because the last drill hole / fixing point is too far from the profile end. The max. distance from first / last hole from profile end 40.0 mm
-
WingLine L
The door springs back in open position.
A stay open element has to be installed.
-
WingLine L
The door tilts when the closing movement is initiated.
1. Solution approach
The central hinge has been mounted incorrectly or the pivot point offset is not correct.
- Mount the central hinge according to the assembly instructions.
2. Solution approach
The guide part is not locked to the profile.
-
WingLine L
When opening, runner and guide parts hit the body side loudly.
Rubber stops must be fitted to running and guide components.