The door is pushed open by displaced air. Separate the cabinet segments with a central wall flush with the corpus or provide ventilation (e. g. in the rear wall).

The door is pushed open by displaced air. Separate the cabinet segments with a central wall flush with the corpus or provide ventilation (e. g. in the rear wall).

1. Solution approach

The running component is knocking against the carcase side as the cup distance for the cup drilling is too small.

• The cup distance for the cup drilling is 5.0 mm.

To the video

2. Solution approach

The running and guide profiles are not mounted parallel to the upper and lower floor.

• The profiles must be mounted in parallel with the mounting aid.

To the video

3. Solution approach

Due to strong deflection of the door, the door edge strikes against the side of the carcase.

• Door deflectors or door clamps are recommended.

To the video

1. Solution approach

The running component is knocking against the carcase side as the cup distance for the cup drilling is too small.

• The cup distance for the cup drilling is 5.0 mm.

To the video

2. Solution approach

The running and guide profiles are not mounted parallel to the upper and lower floor.

• The profiles must be mounted in parallel with the mounting aid.

To the video

3. Solution approach

Due to strong deflection of the door, the door edge strikes against the side of the carcase.

• Door deflectors or door clamps are recommended.

To the video

Hinges with self closing feature must be used.

Hinges with self closing feature must be used.

1. Solution approach

• The cabinet is not in the scale and must be aligned.
• The doors must be aligned.
• The doors are aligned, but the hinges are under tension. Make sure that the joint front to body is even.

To the video

2. Solution approach

The running and guide profiles are not mounted parallel to the upper and lower floor.

• The profiles must be mounted in parallel with the mounting aid.

To the video

3. Solution approach

The door has been lowered too far by height adjuster, making guide component scrape on profile.

To the video

4. Solution approach

The central hinge has been mounted incorrectly or the pivot point offset is not correct.

• Mount the central hinge according to the assembly instructions.

5. Solution approach

Door damper not shortened for full overlay.

• Shorten the door damper

1. Solution approach

• The cabinet is not in the scale and must be aligned.
• The doors must be aligned.
• The doors are aligned, but the hinges are under tension. Make sure that the joint front to body is even.

To the video

2. Solution approach

The running and guide profiles are not mounted parallel to the upper and lower floor.

• The profiles must be mounted in parallel with the mounting aid.

To the video

3. Solution approach

The door has been lowered too far by height adjuster, making guide component scrape on profile.

To the video

4. Solution approach

The central hinge has been mounted incorrectly or the pivot point offset is not correct.

• Mount the central hinge according to the assembly instructions.

5. Solution approach

Door damper not shortened for full overlay.

• Shorten the door damper

The running component is knocking against the carcase side as the cup distance for the cup drilling is too small. The cup distance for the cup drilling is 5.0 mm.

The running component is knocking against the carcase side as the cup distance for the cup drilling is too small. The cup distance for the cup drilling is 5.0 mm.